I have an economy 7 immersion heater setup with a horstmann economy 7 quartz control unit.
Economy 7 immersion heater element.
Initially i thought the bottom economy 7 thermostat had gone but this wasn t the case.
This stopped working around a year ago for no apparent reason and were trying to figure out what the problem would be basically theres 2 switches in the cupboard that the tank.
Interchangeable with sangamo and horstmann economy 7 units.
The benefit of an immersion heater element within your heating system is that it means even the boiler fails you should still be able to get hot water.
The boost mode still works.
Suitable for use with single dual or twin element immersion heaters.
I have an economy 7 water tank fitted with two immersion heaters one at the bottom of the tank and one about halfway up.
A typical immersion heater how it works and how to test it.
I have an economy 7 boiler which has two temperature controlled heating elements.
The lower heater is wired to a circuit which is only live during cheap rate and the upper is wired on a normal circuit which is live all the time.
Economy 7 water not heating overnight the entire water heating unit has had both elements boost and e7 replaced only 3 months ago but in the last 48 hours the e7 has stopped working it is not coming on at night when the radiators come on.
Unsurprisingly they were covered in limescale.
Countdown boost display shows boost time remaining.
I replaced them with new elements.
Hi we have an immersion heater that is supposed to run on economy 7 electricity and heat up our water through the night.
Immersion heaters are electric heating elements that are found in water cylinders to heat water.
If an element in an immersion starts to heat theres no noise.
Pre programmed automatic boost and three on demand options 30 minutes 1 2 hours.
Designed for use with economy 7 off peak rate overnight electricity plans.
I have checked the fuse seems ok.
After 15 years they were replaced as they had started to heat inefficiently.